38
Step 9 :
Place CD Mechanism Unit as shown.
Step 10 :
Connect 24P FFC at connector (CN5002) on Main
P.C.B..
Step 11 :
Connect 7P FFC at connector (CN5001) on Main
P.C.B..
Step 12 :
Check CD Interface P.C.B. according to the diagram
shown.
10.4. Checking of Main P.C.B. (Side
A)
Step 1 :
Remove Top Cabinet Assembly.
Step 2 :
Remove SMPS Unit.
Step 3 :
Remove Front Panel Assembly.
Step 4 :
Remove Main P.C.B..
Step 5 :
Remove CD Mechanism Unit.
Step 6 :
Place Main P.C.B., Front Panel Assembly and SMPS
Unit on insulating material.
Step 7 :
Connect 10P wire at connector (CN1100) on Main
P.C.B..
Step 8 :
Connect 13P extension cable (REEX1203) from
CN8001 on Main P.C.B. to CN900 on Panel P.C.B.
Summary of Contents for SA-PM250EB
