33
6.3.3.
Power Supply & Digital Amplifier Error Code Table
6.3.4.
USB Error Code Table
Error
Code
F61
The abnormalities
In normal operation, when DCDET2 goes
Press [ STOP] on main
in an output or power
to "L" (Low) (Not during POWER OFF
unit for next error.
supply circuit of
condition), F61 appears on FLDisplay
POWER AMP
for 1 second and PCONT goes to
"L" (Low).This is due to speaker output
has DC voltage or fan is not working.
F76
Abnormality in the
In normal operation when DCDET1 is
Press [ STOP] on main
output voltage of
detected "L" (Low) for two consecutive
unit for next error.
stabilized power
times, F76 is displayed on FL for
supply
1 second and after that PCONT will be
turned to "L" (Low). This is due to any of
the DC voltages (+9V, +7V, -7V, +5V,
+5.3V etc.) not available.
Diagnosis Contents
Description of error
Automatic FL Display
Remarks
Error
Code
F650 USB device: Devices
Devices other than the mass storage
Press [ STOP] on main
other than mass
class are connected.
unit for next error.
storage
F651 USB device: Non-Full
The device that the transfer rate did not
Press [ STOP] on main
Speed Device
correspond to Full Speed was
unit for next error.
connected.
F652 USB device:
The device in the interface (subclass)
Press [ STOP] on main
Interface NG
outside correspondence was connected.
unit for next error.
(correspondence interface)
001b: Reduced Block Commands (RBC)
010b: SFF-8020i. MMC-2 (ATAPI)
110b: SCSI transparent command set.
F655 USB device:
The overcurrent of 500mA or more was
Press [ STOP] on main
USB is drawing too
much power.
When the USB system detects a USB
device that is taking too much current,
it will display an "Over current Error" OSD/
Screen. At this state the USB backend/
system will not be usable temporarily, the
corresponding "U**" error code will be send
to Opecon, and "USB Overcurrent Error"
displayed on the FL.
USB OVERCURRENT ERROR
(scrolling)
Switch to DVD/CD mode,
remove USB and turn off
the unit.
Overcurrent detection
detected in VDD USB, and the USB
unit for next error.
device driver function was intercepted.
(To intercept the current.)
Diagnosis Contents
Description of error
Automatic FL Display
Remarks
Summary of Contents for SA-PT470EB
Page 13: ...13 ...
Page 43: ...43 Fig 3 Fan Connector CN5501 ...
Page 49: ...49 9 2 Main Components and P C B Locations ...
Page 109: ...109 ...
