Simple setup
RQT7534
8
The remote control
STEP
5
Do not;
¡
mix old and new batteries.
¡
use different types at the same time.
¡
heat or expose to flame.
¡
take apart or short circuit.
¡
attempt to recharge alkaline or manganese batteries.
¡
use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
Remove if the remote control is not going to be used for a long period
of time. Store in a cool, dark place.
7
Use
Aim at the sensor, avoiding obstacles, at a maximum range of 7 m
(23 feet) directly in front of the unit.
Batteries
Remote control
2
2
R6/LR6, AA, UM-3
1
3
¡
Insert so the poles (+ and –)
match those in the remote
control.
¡
Do not use rechargeable
type batteries.
Other speaker setup options
Front/Surround speaker
Center speaker
162 mm
(6
3
/
8
")
Note
The wall or pillar on which the speakers are to be attached should
be capable of supporting 5 k
g
(11 Ib.) per screw.
1
Screw a screw (not included) into the wall.
2
Fit the speaker securely onto the screw with the
hole or holes.
5 mm (
13
/
64
"), pitch 0.8 mm (
1
/
32
")
Speaker stand
(not included)
Attach the stands
with these holes.
Plate thickness plus 7 to
10 mm (plus
9
/
32
" to
13
/
32
")
Attaching to a wall
Fitting speaker stands (optional)
Preparation
Ensure the stands meet these conditions before purchasing them.
¡
Observe the diameter and length of the screws and the distance
between screws as shown in the diagram.
¡
The stands must be able to support over 5 k
g
(11 lb.).
¡
The stands must be stable even if the speakers are in a high
position.
Notes on speaker use
¡
You can damage your speakers and shorten their useful life if
you play sound at high levels over extended periods.
¡
Reduce the volume in the following cases to avoid damage.
– When playing distorted sound.
– When the speakers are receiving howling from a record
player, noise from FM broadcasts, or continuous signals from
an oscillator, test disc, or electronic instrument.
– When adjusting the sound quality.
– When turning the unit on or off.
If irregular coloring occurs on your television
These speakers are designed to be used close to a television,
but the picture may be affected with some televisions and setup
combinations.
If this occurs, turn the television off for about 30 minutes.
The television’s demagnetizing function should correct the
problem. If it persists, move the speakers further away from the
television.
Caution
¡
Use the speakers only with the recommended
system. Failure to do so may lead to damage
to the amplifier and/or the speakers, and may
result in the risk of fire. Consult a qualified
service person if damage has occurred or if
you experience a sudden change in
performance.
¡
Do not attempt to attach these speakers to
walls using methods other than those
described in this manual.
RQT7534(2)PC(06-9)
10/2/04, 4:42 pm
8
