9
Operating Instructions
Assembling the unit
Refer to the following when placing this unit on a table or in a rack. For wall mount, refer to the
installation instructions. (
>
21)
Preparation
≥
To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
≥
Keep the screws out of reach of children to prevent swallowing.
≥
Do not hold this unit in one hand to avoid injury by dropping this unit when carrying.
1
On the rear of the unit:
Place the wall mount bracket by aligning the holes in the wall mount bracket
with the projecting parts
A
.
2
Screw the wall mount bracket firmly into place.
≥
Screw tightening torque: 80 N
0
cm (17.98 lbf-ft) to 120 N
0
cm (26.98 lbf-ft).
≥
Repeat the steps above when installing the second wall mount bracket.
3
Thread a cord (not supplied) through each wall mount bracket.
≥
Make sure to use a cord which is capable of
supporting over 20 k
g
(44.1 lbs).
A
Rear of this unit
B
Fall prevention
cord (not supplied)
4
After all the necessary connections are finished (
>
10)
Place the unit in the desired position and attach each cord onto the rack or
table.
≥
Attach each cord to a different screw eye.
≥
Make sure that there is no more than a 3 cm (1
3
/
16
q
)
slack.
A
This unit
B
Fall prevention cord (not supplied)
C
Rack or table
D
Screw eye (not supplied)
≥
Attach at a position capable of supporting over 20 k
g
(44.1 lbs).
Professional installation is required.
The installation should never be done by any other than a qualified installation specialist.
To prevent the unit from falling
e.g.
SCHTB50_10PPC_RQTX1165-P.book Page 9 Monday, May 10, 2010 11:58 AM
Summary of Contents for SAHTB10 - HOME THEATER AUDIO SYSTEM
Page 27: ...27 Installation Instructions ...
