12
6
Adjust the safety holder with the cord attached (
>
11), to fit the projecting
parts and screw the safety holder firmly into place.
≥
Screw tightening torque: 80 N
0
cm (17.98 lbf-ft) to 120 N
0
cm (26.98 lbf-ft).
≥
The safety holder is to minimize the possibility of damage and harm, but it does not guarantee this effect.
≥
Keep the safety holders out of reach of children to prevent swallowing.
≥
Keep the screws out of reach of children to prevent swallowing.
7
Attach this unit to the wall mount bracket.
8
Screw the safety holder onto the wall mount brackets.
≥
Screw tightening torque: 80 N
0
cm (17.98 lbf-ft) to 120 N
0
cm (26.98 lbf-ft).
≥
The safety holders are designed to prevent the unit from falling off the wall mount bracket.
≥
Keep the screws out of reach of children to prevent swallowing.
≥
Keep the safety holders out of reach of children to prevent swallowing.
9
Attach the cord to a wall with a screw (not supplied).
≥
Make sure that the slack is minimal.
≥
Keep the screws out of reach of children to prevent swallowing.
≥
Check the strength of the installation location. The position in the wall where the screw is to be attached should be capable of
supporting over 33 k
g
(72.8 lbs). If the strength at any of these positions is lacking, provide sufficient reinforcement.
H
Screw with washer (supplied)
I
Safety holder (supplied)
J
Projecting part
K
Wall mount
bracket
(supplied)
L
Wall mount
holder
M
Screw without washer (supplied)
N
Safety holder (supplied)
O
Wall mount bracket (supplied)
P
Wall
Q
Screw eye (not supplied)
R
Cord (not supplied)
突起部
≥
The safety holder is placed diagonally.
SC-HTB520PP_RQTX1278-Y.book Page 12 Friday, February 18, 2011 8:48 AM
