Reference
23
There is no audio.
The power of the unit turns off automatically.
(When this unit detects a problem, a safety
measure is activated and this unit automatically
switches to standby mode.)
≥
There is a problem with the amplifier.
≥
Is the volume extremely high?
If so, lower the volume.
≥
Is this unit placed in an extremely hot place?
If so, move the unit to a cooler place and wait a
few moments and then try to turn it on again.
If the problem persists, turn the unit off and remove
the AC power supply cord and consult your dealer.
Please be sure to remember the indicators that
were blinking and inform the dealer.
No power.
Ensure the AC power supply cord of the active
subwoofer is connected properly.
After turning the subwoofer on, it immediately
turns off.
Unplug the AC power supply cord and consult your
dealer.
No sound from the subwoofer.
≥
Check that the active subwoofer is turned on.
≥
Check that the wireless link indicator lights green.
(
>
17)
The wireless link indicator lights red.
≥
There is no link between this unit and the active
subwoofer.
j
Check that this unit is turned on.
j
Ensure that the digital transmitter is fully inserted
into the digital transmitter dock on this unit.
(
>
16)
j
Turn the active subwoofer off and then back on.
Alternatively, turn the active subwoofer off,
disconnect the AC power supply cord and then
reconnect it.
≥
Consult your dealer if the problem persists.
The audio from the subwoofer is interrupted.
The active subwoofer is automatically seeking a
clear channel. If the interference persists, try
moving the other wireless devices to another
location outside the range of the active subwoofer
or move the active subwoofer nearer to this unit.
(
>
9)
The wireless link indicator lights red and green
alternately.
Turn the subwoofer off, disconnect the AC supply
cord and then reconnect it.
Consult your dealer if the problem persists.
When other Panasonic products respond to this
unit’s remote control, change the remote control
code on this unit and the remote control.
Preparation
≥
Turn off all other Panasonic products.
≥
Turn on this unit.
Change the remote control to code 2:
1
Aim the remote control at this unit’s remote
control sensor.
2
Press and hold [MUTE] and [BD/DVD] on the
remote control for more than 4 sec.
A
will blink for 10 sec when the code of this unit is
changed.
≥
If the unit does not operate after changing the code, repeat
steps
1
and
2
.
≥
To change the remote control to code 1, repeat the steps
above, but replace [BD/DVD] with [TV].
Audio information
∫
Compatible audio formats
This unit is compatible with the following formats:
Dolby Digital, DTS Digital Surround, 2-channel
LPCM and multi-channel LPCM.
Active Subwoofer
Remote control code
TV
BD/DVD
DTS
PCM
D
A
SC-HTB520PP_RQTX1278-Y.book Page 23 Friday, February 11, 2011 11:25 AM
