Slide # 18
Models:
SA-PT660
SA-PT760
SA-PT960
SA-PT1060
SH-FX67, 85
Outline
Wireless
Mech
Pwr Supply
Protection
Audio
5 Disc Mechanism Assembly Transfer Alignment
– Trays Out 3/4
Preparing the Traverse unit for docking:
3. Slide the top #336 sub slide plate inside the
cutout to the left or as far as it will go without
force (pictured down).
4. This permits the other end of the #336 slide
plate to engage gear #331.
5. Rotate the #331 gear (cw) so the plastic arm
of the sub plate points past the triangle cutout, all
the way left as shown.
This is the elevator position.
6. The rear Traverse portion of the mech is ready
for docking with the front tray assembly.
7
. Optional - At the middle tray area (fig 4), you may
manually rotate the stocking motor gear so the black gear
hole lines up here. It will pwr to this position anyway.
8. Plug in the mech’s 3 ribbon cables and test
.
rear
#331 gear
front
left
Figure 3
Figure 4
cutout
