8
RQT8043
RQTX0202
ESPAÑOL
ESPAÑOL
ESPAÑOL
ESPAÑOL
ESPAÑOL
Preparing the remote control
Use alkaline or manganese batteries.
Insert so the poles (+ and –) match those in
the remote control.
R6/LR6, AA
Aim at the remote control signal sensor (
\
page 9), avoiding
obstacles, at a maximum range of 7 m directly in front of the
unit.
Note on using the remote control
• Do not mix old and new batteries.
• Do not use different types of batteries at the same time.
• Do not take apart or short circuit the batteries.
• Do not attempt to recharge alkaline or manganese
batteries.
• Do not use batteries if the covering has been peeled off.
Do not heat or expose to fl ame.
Do not leave the battery(ies) in an automobile exposed
to direct sunlight for a long period of time with doors and
windows closed.
• Mishandling of batteries in the remote control can cause
electrolyte leakage, which may cause a fi re.
• Remove the batteries if the remote control is not going
to be used for a long period of time. Store in a cool, dark
place.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.
•
•
DEMO function
7
, –DEMO
When the unit is fi rst plugged in, a demonstration of its
functions may be shown on the display.
If the demo setting is off, you can show a demonstration by
selecting “DEMO ON”.
Press and hold [
7
, –DEMO] (demo) on the main unit.
The display changes each time you press and hold the
button.
NO DEMO (off) DEMO ON (on)
While in standby mode, select “NO DEMO” to reduce power
consumption.
Note:
DEMO function cannot be turned on when dimmer function
is on.
Handling of the disc trays and discs
Not doing the following will cause damage to the unit.
Removing the mains plug
Press [
y
/I] to turn off the unit and remove the mains plug only after all the displays have disappeared.
Inserting a disc
Tray caution
• Place the disc correctly with the label facing up as shown in
the diagram.
• Insert one disc into the tray.
• Always press [
0
, OPEN/CLOSE] to insert
or remove a disc.
• Do not push or pull out the tray by hand as
this will cause an accident.
rqtx0202-B(en).indd 8
rqtx0202-B(en).indd 8
1/13/09 1:55:25 PM
1/13/09 1:55:25 PM