Confidential
Until:
23 May 2018
5
T
Q
BJ
210
7
5
ENGLISH
Making the connections
Connect the AC mains lead only after all the other connections have been made.
1
Connect the AM loop antenna.
Stand the antenna up on its base until it clicks.
2
Connect the FM indoor antenna.
Put the antenna where reception is best.
3
Connect the speakers.
Connect the speaker cables to the corresponding
terminal.
4
Connect the AC mains lead.
Do not use any other AC mains lead except the
supplied one.
Conserving power
The system consumes a small amount of power even
when it is in standby mode. Disconnect the power
supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Note:
Keep the antennas away from the speaker cables and the AC
mains lead to avoid picking up noise.
4
SPEAKERS ( TO SB-AKX700 )
3
2
1
For the United Kingdom and Ireland
Connect the FM outdoor antenna.
Use an outdoor antenna if reception is poor.
Note:
•
Do not use the outdoor antenna during a lightning storm.
•
Disconnect the outdoor antenna if you do not use the
system.
Adhesive tape
(not supplied)
Antenna plug adaptor
75
Ω
coaxial cable
(not supplied)
FM outdoor antenna
(not supplied)
SPEAKERS ( TO SB-AKX700 )
(For the AC mains plug of three pins)
READ THE “Caution for AC mains lead” BEFORE
CONNECTION.
To household
mains socket
Attaching the ferrite core near to the terminal
A
Pull on the tabs (both sides)
to open.
B
Put the AC mains lead onto
one of the concave surfaces.
C
Coil the AC mains lead
around the ferrite core and
onto the other concave
surface.
D
Close the ferrite core until it
clicks
.
Note:
Failure to attach the ferrite core to
the AC mains lead may cause
interference to other devices
nearby.
TQBJ2107.book Page 5 Wednesday, May 2, 2018 11:02 AM
offset printing
