Getting s
tar
te
d
13
VQT3M06
[BTT370]
1
Use of the speaker cable stickers is
convenient when making cable connections.
e.g. Front speaker (L)
A
Speaker cable sticker
(supplied)
B
Connector
Be sure to match the number on each sticker with the connector colour.
2
Connecting the speaker cables. Insert the
wire fully, taking care not to insert beyond
the wire insulation.
e.g. Surround speaker
[BTT270]
≥
Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers.
≥
Don’t use a front speaker as a surround speaker or vice versa. Verify the type of speaker with the label on the rear of the speaker before connecting the appropriate cable.
≥
To avoid injury by falling or dropping the speaker, place the speaker cables with care not to stumble or hook.
≥
Do not hold the speaker in one hand to avoid injury by dropping the speaker when carrying.
[BTT775]
[BTT770]
[BTT370]
∫
Preventing the speakers from falling
≥
Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
≥
Use a string of less than
‰
2.0 mm, which is capable of supporting over 10 k
g
.
e.g.
[BTT775]
A
String (not supplied)
Thread from the wall to the speaker and tie tightly.
B
Rear of the speaker
C
Screw eye (not supplied)
D
Wall
E
Approx.150 mm
Preparing cables and making connection
Thread the speaker cable through the base.
≥
Use cables with a white connector and red connector.
Leave about
110 mm
Insert the wire fully.
r
: White
s
: Blue line
Pull the cable
straight along the
line and slide into
the groove.
Tighten securely.
Press into the groove.
Push!
Back of the base
Speaker cable sticker
Colour
1
FRONT (L)
WHITE
2
FRONT (R)
RED
3
SURROUND (L)
BLUE
4
SURROUND (R)
GREY
5
CENTRE
GREEN
6
SUBWOOFER
PURPLE
FRONT
Lch
Push!
r
: White
s
: Blue line
SCBTT775_770_370_270EBEPGN_VQT3M06.book 13 ページ ２０１１年１月１８日 火曜日 午後６時１４分
