13
T
Q
BJ
207
4
Others
Auto off
This system automatically switches off when you do not
use it for approximately 20 minutes.
1
Press [SETUP] repeatedly to select “AUTO OFF”.
2
Press [
R
,
T
] to select “ON” and then press [OK].
To cancel, select “OFF”.
Note:
This function does not work when you are in radio source or
when a Bluetooth
®
device is connected.
Bluetooth
®
standby
This function automatically switches on the system when
you establish a Bluetooth
®
connection from a paired
device.
1
Press [SETUP] repeatedly to select
“BLUETOOTH STANDBY”.
2
Press [
R
,
T
] to select “ON” and then press [OK].
To cancel, select “OFF”.
Charging a device
This system can supply power to a device, such as a
smartphone, connected to the USB port.
Note:
•
Use a cable compatible with the device.
•
Use the charger supplied with the device if power is not
supplied to the device.
•
Do not use a cable or connect a device that exceeds the
rated value of 5 V, 1.5 A.
•
Examine the screen of the device to check if charging is
complete. Disconnect the device after charging.
•
Once fully charged, remove the USB cable from the USB
port.
•
After the device has started charging, you can switch the
unit to standby mode.
–
When charging a depleted device, do not switch the unit
to standby mode until the device becomes operational.
•
Depending on the device, power may not be supplied to it.
•
Read the operating instructions of the device for details.
Software update
Occasionally, Panasonic may release updated software
for this unit that may add or improve the way a feature
operates. These updates are available free of charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
█
Checking the software version
1
Press [SETUP] repeatedly to select “SW VER.”
and then press [OK].
The software version is shown.
2
Press [OK] again to exit.
SC-HC302.300.GN.GS TQBJ2074 En_rev1.fm Page 13 Friday, March 23, 2018 9:59 AM
