RQTX1083
13
DAB
(continued)
DAB operation
DAB Auto scan
Press and hold [PLAY MODE] until “DAB AUTO SCAN”
appears.
When a frequency is tuned using Auto scanning, the ensemble
corresponding to the frequency is displayed for approximately
2 seconds.
When updating memory with Auto scan, preset stations will
be erased. Preset them again (
➡
right).
Total stations received is displayed for approximately
2 seconds.
•
•
g
Presetting channel
Press [
u
] or [
i
] to select the station.
Press [PROGRAM].
Press the numeric buttons to select the channel.
The station occupying a channel is erased if another station
is preset in that channel.
To preset more stations, press [PLAY MODE] to select
“STATION TUNE” and then repeat steps
to
.
Maximum channels presettable is 20.
You cannot preset stations when the station is not
broadcasting or when the secondary service is selected.
g
Selecting a preset channel
Press [PLAY MODE] to select “PRESET TUNE”.
Press [
u
] or [
i
] to select the channel.
Alternatively, press the numeric buttons to select the channel.
•
•
•
Presetting
Press [DISPLAY, –DIMMER] to select the display.
The information scroll through the display.
Each time you press the button:
Listening to the secondary service
Display
Press [PLAY MODE] to select “STATION TUNE”.
Each time you press the button:
“STATION TUNE” “PRESET TUNE”
Press [
u
] or [
i
] to select a station.
The station name changes in alphanumeric order.
Press [RADIO] to select “DAB”.
The station first in alphanumeric
order is broadcast.
If you are selecting DAB for the
first time, “DAB AUTO SCAN”
is displayed, stations that
are currently receivable are
memorised.
When a frequency is tuned, the
ensemble corresponding to the
frequency is displayed.
“SCAN FAILED” appears if no stations are memorised. If
this occurs, adjust the antenna and try Auto scanning or
change the Auto scan frequency range (
➡
page 14).
•
Dynamic label
(information about the
broadcast)
PTY display
(program type)
Ensemble label
(the name of the ensemble)
Frequency display
Time display
Press the
[DAB SECONDARY]
to select the secondary service.
“ ” is displayed if there is a secondary service broadcast.
The secondary services are selected each time the button
is pressed. The primary service is returned to after the last
secondary service.
Total number of receiving
stations is displayed.
