12
VQT4D53
≥
For a safety measure to prevent the speakers from falling, refer to page 16.
≥
To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
Attach the front ornaments.
≥
Keep the screws out of reach of children to prevent swallowing.
≥
Be sure to insert the screws following the order as indicated in the illustration.
Connect the speaker cables.
≥
Insert the wire fully, taking care not to insert beyond the wire insulation.
≥
To make sure that the speaker cable is connected to the correct speaker, match the color of the speaker connector with the
color of the L/R indicator on the speaker label so as not to connect the speaker cable to the wrong speaker.
Drive a screw (not supplied) into the wall.
≥
Use the measurements indicated below to identify the screwing positions on the wall.
≥
Leave at least 20 mm (
25
/
32
q
) of space above and on each side of the speaker to allow enough space for fitting the speaker.
≥
The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 k
g
(72.8 lbs).
≥
Keep the screws out of reach of children to prevent swallowing.
Place the speakers vertically
∏
1 Speaker (L)
∏
1 Speaker (R)
∏
2 Speaker cables
(L): WHITE
(R): RED
∏
4 Screws
∏
2 Front
ornaments
1
Insert the wire fully.
r
: White
s
: Blue line
2
Press into the groove.
2
1
Front view
Rear view
Push
SC-HTB20P_VQT4D53_eng.book 12 ページ ２０１２年１月１６日 月曜日 午後８時３分
