Getting started
RQT9690
13
Connect the speaker cables.
≥
Insert the wire fully, taking care not to insert beyond the wire insulation.
Drive a screw into the wall.
≥
Use the measurements indicated below to identify the screwing positions on the wall.
≥
Leave at least 20 mm (
25
/
32
q
) of space above and on each side of the speaker to allow enough space for fitting the
speaker.
≥
The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 k
g
(72.8 lbs).
≥
Keep the screws out of reach of children to prevent swallowing.
Fit the speaker(s) securely onto the screw(s).
≥
Place the speaker that is connected with the speaker cable with a red connector on the observers’ right, and connect with
the speaker cable with a white connector on the observers’ left.
1
Insert the wire fully.
r
: White
s
: Blue line
2
Press into the groove.
A
At least 30 mm (1
3
/
16
q
)
B
‰
4.0 mm (
5
/
32
q
)
C
‰
7.0 mm to
‰
9.4 mm
(
9
/
32
q
to
3
/
8
q
)
D
Wall or pillar
E
5.5 mm to 6.5 mm
(
7
/
32
q
to
1
/
4
q
)
F
Front speaker
(Rear view)
G
102 mm (4
1
/
32
q
)
H
37 mm (1
15
/
32
q
)
I
Wall mounting
hole
J
WHITE
: Left speaker channel (L)
K
RED
: Right speaker channel (R)
DO
DO NOT
≥
Move the speaker so that the screw is in this
position.
≥
In this position, the speaker will likely fall if moved to
the left or right.
Push
Red
White
SC-HTB450_RQT9690_mst.book Page 13 Wednesday, February 1, 2012 5:58 PM
