Operations
RQT9690
27
∫
Remote control code
When other Panasonic devices respond to this system’s
remote control, change the remote control code on the
main unit and the remote control.
Preparation
≥
Turn off all other Panasonic products.
≥
Turn on the main unit.
Change the remote control code to code 2:
1
Aim the remote control at this system’s remote
control sensor.
2
Press and hold [MUTE] and [
] on the remote
control for more than 4 sec.
≥
All the indicators will blink for 10 sec when the code of
this system is changed.
≥
The setting is maintained until it is changed again.
≥
If this system does not operate after changing the code,
repeat steps 1 and 2.
≥
To change the remote control code to code 1, repeat the
steps above, but replace
[
]
with [TV].
∫
To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume
is set low, for example, It is possible to reduce the dialog
enhancing effect as follows:
Press and hold [TV] on the remote control and followed by
[
s
VOL] on the main unit for more than 2 sec.
≥
All the indicators will blink once when the clear-mode dialog
effect is reduced.
≥
Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
∫
To turn off VIERA Link “HDAVI
Control”
When “HDAVI Control” compatible equipment does not
work well with this system, for example, it is possible to
turn off this function as follows:
≥
When VIERA Link is turned off the ARC function is not
available. Be sure to connect the optical digital audio
cable. (
>
19)
1
Press and hold [MUTE] on the remote control
and followed by [
s
VOL] on the main unit for
more than 2 sec.
2
After the setting has changed, turn off all the
connected devices and then turn them on
again.
≥
All the indicators will blink once when VIERA Link “HDAVI
Control” is turned off.
∫
To turn off the volume limitation
If a state of the lowered volume disturbs you every time
this system turns on, for example, it is possible to turn off
this function as follows:
Press and hold [MUTE] on the remote control and
followed by [VOL
r
] on the main unit for more than 2 sec.
≥
All the indicators will blink once when the volume limitation
is turned off.
The settings of the clear-mode dialog effect, VIERA Link
“HDAVI Control”, and the volume limitation remain intact even
if you switch this system to standby mode. To turn these 3
functions back on, this system must be set back to the factory
preset. (
>
28)
Others
The following settings are unnecessary under
general usage conditions of the system.
SC-HTB450_RQT9690_mst.book Page 27 Tuesday, March 6, 2012 2:17 PM
