8
VQT4U48
Others
The sleep timer can turn the unit off after a set time.
1
Press [SETUP] to select “SLEEP”.
2
Press [
3
,
4
] to set the time (in minutes) and then
press [OK].
“SLEEP 30”
,.
“SLEEP 60”
,.
“SLEEP 90”
,.
“SLEEP 120”
^---------------------.
“OFF” (Cancel)
(----------------------J
≥
The remaining time is indicated on the unit’s display except
when other operations are performed.
The brightness of this unit’s display can be changed.
1
Press [SETUP] repeatedly to select “DIMMER”.
2
Press [
3
,
4
] to select “ON” and then press [OK].
≥
To cancel the dimmer, select “OFF” in step 2.
As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for approx. 30 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select “AUTO OFF”.
2
Press [
3
,
4
] to select “OFF” and then press [OK].
≥
To turn automatic standby on, select “ON” in step 2.
≥
When connected to a Bluetooth
®
device, the automatic
standby function does not work.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [
, AUX] to select “AUX”.
2
While pressing and holding [
/ AUX] on the unit,
press and hold [SOUND] on the remote control
until the unit’s display shows “REMOTE 2”.
3
Press and hold [OK] and [SOUND] on the remote
control for at least 4 seconds.
≥
To change the mode back to “REMOTE 1”, repeat the steps
above but replace the button pressed on the remote control
from [SOUND] to [
, AUX].
Sleep timer
Display brightness
Automatic standby
Changing the unit and remote
control code
SC-NE1_EG~VQT4U48.book 8 ページ ２０１３年１月１５日 火曜日 午後１時４分
