3
TQ
BJ
09
79
3
Making the connections
Connect the AC mains lead only after all the other
connections have been made.
1
Connect the DAB antenna.
Be sure to tighten fully the nut.
Do not use any other DAB antenna except the
supplied one.
Use an outdoor antenna if the reception is poor.
2
Connect the speakers.
3
Connect the AC mains lead.
Do not use an AC mains lead from other equipment.
Conserving power
The system consumes a small amount of power
(
Z
“Specifications”) when it is in standby mode.
Disconnect the power supply if you do not use the
system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Placement of speakers
The left and right speakers are the same.
Use only the supplied speakers.
You can cause damage to the system and decrease the
sound quality if you use other speakers.
Note:
• Keep your speakers more than 10 mm from the main unit
for ventilation.
• Put the speakers on a flat safe surface.
• These speakers do not have magnetic shielding. Do not put
them near TVs, PCs or other equipment easily influenced
by magnetism.
• When you play at high levels for a long period, it can cause
damage to the speakers and decrease the life of the
speakers.
• Decrease the volume in these conditions to prevent
damage:
– When the sound is distorted.
– When you adjust the sound quality.
• To prevent damage to the speakers, do not touch the
speaker cones if you remove the nets.
Be careful not to cross
(short-circuit) or reverse
the polarity of the speaker
wires as doing so may
damage the speakers.
(6
:
)
(6
:
)
3
2
1
Adhesive tape
(not supplied)
B
A
Red
Black
CAUTION!
•
Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
occurs or if there is a sudden apparent change in
performance.
•
Do the procedures included in these instructions
when you attach the speakers.
To household
mains socket
ENGLISH
TQBJ0979_en.pl.cz.es.book Page 3 Monday, August 22, 2016 4:24 PM
offset printing
