22
TQ
BM0877
D:\New folder\PM700\Source\xml\PM700\PM700EB.EG_TQBM0877_EN.fm
Clock and timers
Setting the clock
This is a 24-hour clock.
1
Press [SETUP] repeatedly to select “CLOCK”.
2
Press [
R
,
T
] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select “CLOCK” and then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Play timer
(Except for Bluetooth
®
source)
You can set the timer to come on at a certain time to wake you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select “TIMER ADJ”.
2
Press [
R
,
T
] to set the start time and then press [OK].
3
Do step 2 again to set the end time.
4
Press [
R
,
T
] to select the source you want to play and then press [OK].
To start the timer
1
Prepare the source you want to listen to (disc, USB or radio) and set the volume.
2
Press [SETUP] repeatedly to select “TIMER SET”.
3
Press [
R
,
T
] to select “SET” and then press [OK].
“
#
” is shown.
To cancel, select “OFF”.
The system must be switched off for the timer to operate.
To check the setting
Press [SETUP] repeatedly to select “TIMER ADJ” and then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
• The timer starts at a low volume and increases gradually to the preset level.
• The timer comes on at the set time every day if the timer is on.
• If you switch off the system and then switch on again while a timer is in operation, the timer will not stop at the
end time.
PM700EB.EG_TQBM0877_EN.fm Page 22 Wednesday, March 15, 2023 2:48 PM
