RQTV0271
5
5
ENGLISH
Optional antenna connections
FM outdoor antenna
AM outdoor antenna
FM outdoor antenna
(not included)
75
Ω
coaxial cable
(not included)
Rear panel of
this main unit
AM loop antenna
(included)
AM outdoor antenna
(not included)
Rear panel of
this main unit
• Never use an outdoor antenna during a lightning storm.
• You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.
• Disconnect the FM indoor antenna if an FM outdoor antenna is installed.
• Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m of vinyl-covered wire horizontally along a window
or other convenient location.
Preparing the remote control
2,2!!
2
Insert so the
poles (+ and –)
match those in the
remote
control.
3
1
Batteries:
• Remove the batteries if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
• Mishandling of batteries can cause electrolyte leakage, which can severely
damage the remote control.
• Do not use rechargeable type batteries.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed to direct sunlight for a
long period of time with doors and windows closed.
Do not:
• mix old and new batteries.
• use different types of batteries at the same time.
• take apart or short-circuit the batteries.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
■
Use
Aim at the remote control signal sensor (
➡
page 6), avoiding obstacles, at a
maximum range of 7 m directly in front of the unit.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer’s instructions.
DEMO function
When the unit is fi rst plugged in, a demonstration of its functions may be shown
on the display.
If the demo setting is off, you can show a demonstration by selecting “DEMO
ON”.
Press and hold [
7
, –DEMO].
The display changes each time the button is held down.
$%-//&&
$%-//.
While in standby mode, select “DEMO OFF” to reduce power consumption.
PMX3_E_EN.indd 5
PMX3_E_EN.indd 5
6/17/08 10:14:47 AM
6/17/08 10:14:47 AM
