6
RQT0A75
Inserting media
1
Press [
<
] on this unit to open the disc tray.
2
Put in a disc with the label facing up.
3
Press [
<
] again to close the disc tray.
Insert the USB device directly. Do not use any USB
extension cable.
≥
Please disconnect the USB device if you finish using.
≥
Before removing the USB device, select a source other than
“USB”.
Charging starts when a device (rated value: DC 5 V/
1.5 A) is connected to the USB port of this unit.
1
Turn the unit on.
2
Select a source other than “USB”.
3
Connect a device.
≥
Confirm from the screen of the connected device, etc. to
make sure charging has started.
≥
After the device has started charging, you can turn the
unit to standby mode.
– When charging a depleted device, do not turn the unit
to standby mode until the device becomes
operational.
≥
A cable compatible with your device is required. Use the
cable that comes with your device.
≥
Even if you connect a cable compatible with the USB port of
this unit, your device may not be charged. In that case, use
the charger that comes with the device.
≥
Depending on your device, using other chargers may not
work. Check the operating instructions of your device before
use.
≥
Do not connect a device with a rated value higher than 5 V/
1.5 A to this unit.
≥
To check if charging is complete, look at the screen of the
connected device, etc.
≥
Once fully charged, remove the USB cable from the USB
port.
≥
When moving this unit, be sure to remove all media and turn this unit to standby mode.
Inserting a disc
Connecting a USB device
Charging a device
USB cable
(not supplied)
To the compatible device
SC-RS50_PC_RQT0A75-C.book 6 ページ ２０１６年２月２３日 火曜日 午前９時５４分
