1 Connection of the
Speaker Cables
•
Be sure to connect speaker cables before
connecting the AC power supply cord.
•
The load impedance of any speaker used with this
unit must be 6˜/12˜.
•
Be sure to connect the cable from the right speaker
to the right terminal and the cable from the left speaker to
the left terminal.
Strip off the outer covering, and twist the center
conductor. Make sure the bare ends of the wires are
not unravelled. (If they are, twist them tight again.)
Insert the wire to the rear panel of the unit and close
the lever.
Notes :
•
To prevent damage to circuitry, never short-circuit
positive (+) and negative (-) speaker wires.
•
Be sure to connect only positive (red) wires to
positive (+) terminals and negative (black) wires to
negative (-) terminals.
2 Connection of the Wiring Diagram
3 Cabinet Parts Location
SB-TM82
Summary of Contents for SC-TM82AV
Page 2: ... ...
Page 50: ...PRINTING PCB BOARD ...
