RQT7800
4
(R)
(L)
1
2
1
2
To household
AC outlet
Set-up
5
AC power supply cord
3
Speakers
Placement
Connection
Connect the AC power supply cord only after all other connections have been made.
Optional antenna connections (
A
page 10)
Preparation
Twist and pull off the vinyl tip of the antenna wires and speaker cords.
OR
If the speaker cords do not have vinyl tips, directly connect them to the terminals.
Insertion of connector
Even when the connector is perfectly inserted, depending
on the type of inlet used, the front part of the connector
may jut out as shown in the drawing.
However there is no problem using the unit.
GCP
only
If the power plug does not fit your socket, use the power
plug adaptor (included).
Note
The included AC power supply cord is for use with this unit only. Do not use it with
other equipment.
For your reference
To save power when the unit is not to be used for a long time, unplug it from the
household AC outlet. You will need to reset some memory items after plugging in
the unit.
Connector
Appliance inlet
Approx. 6 mm
4
GCP
only
Voltage selector
Use a flat-head screwdriver to set
the voltage selector on the rear
panel to the appropriate position for
the area in which this system is
used.
1
FM indoor antenna
2
AM loop antenna
Stand the antenna up on its base.
Adhesive tape
Affix where reception
is best.
Note
•
Keep your speakers at least 10 mm away from the
system for proper ventilation.
•
These speakers do not have magnetic shielding. Do
not place them near televisions, personal computers
or other devices easily influenced by magnetism.
•
You cannot take the front net off the speakers.
Speakers are designed identically so that no left or
right channel orientation is necessary.
1
3
2
Black (–)
Red (+)
Black
Red
Use only the supplied speakers.
The combination of the main unit and speakers
provide the best sound. Using other speakers
can damage the unit and sound quality will be
negatively affected.
Notes on speaker use
•
You can damage your speakers and shorten
their useful life if you play sound at high levels
over extended periods.
•
Reduce the volume in the following cases to
avoid damage.
– When playing distorted sound.
– When adjusting the sound quality.
Connect the left
(L) side in the
same way.
VOLT ADJ
Turning the demo function on/off
DISP, –DEMO
220–240
V
110–127
V
Caution
•
Use the speakers only with the recommended system. Failure
to do so may lead to damage to the amplifier and/or the
speakers, and may result in the risk of fire. Consult a qualified
service person if damage has occurred or if you experience
a sudden change in performance.
•
Do not attach these speakers to walls or ceilings.
When the unit is first plugged in, a demonstration of its functions may
be shown on the display.
If the demo setting is off, you can show a demonstration by selecting
“DEMO ON”.
Press and hold [DISP, –DEMO].
The display changes each time the button is held down.
NO DEMO (off)
DEMO ON (on)
While in the standby mode, select “NO DEMO” to reduce power
consumption.
Note
DEMO function cannot be turned on when Dimmer is on.