Getting s
tar
te
d
13
VQT2W23
A
Speaker cable sticker
(supplied)
B
Connector
Be sure to match the number on each sticker with the
connector colour.
≥
Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers.
≥
Don’t use a front speaker as a surround speaker or vice versa. Verify the type of speaker with the label on the rear of the speaker before
connecting the appropriate cable.
≥
To avoid injury by falling or dropping the speaker, place the speaker cables with care not to stumble or hook.
≥
Do not hold the speaker in one hand to avoid injury by dropping the speaker when carrying.
∫
Preventing the speakers from falling
≥
Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
≥
Use a string of less than
‰
2.0 mm, which is capable of supporting over 10 k
g
.
A
String (not supplied)
Thread from the wall to the speaker and tie tightly.
B
Rear of the speaker
C
Screw eye (not supplied)
D
Wall
E
Approx.150 mm
Preparing cables and making connection
Speaker cable sticker
Colour
1
FRONT (L)
WHITE
2
FRONT (R)
RED
3
SURROUND (L)
BLUE
4
SURROUND (R)
GREY
5
CENTRE
GREEN
6
SUBWOOFER
PURPLE
FRONT
Lch
1
Use of the speaker cable stickers is convenient
when making cable connections.
e.g. Front speaker (L)
2
Push!
r
: White
s
: Blue line
Connecting the speaker cables. Insert the wire fully,
taking care not to insert beyond the wire insulation.
e.g. Surround speaker
[BTT350]
SCBTT755_350EBGN_VQT2W23.book 13 ページ ２０１０年６月１８日 金曜日 午後４時５８分
