4
RQT7985
Simple setup
Preparation
≥
To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥
For assembly, use a Phillips-head screwdriver.
≥
Make sure you have all the indicated components before starting assembly, setup, and connection.
≥
There is no difference between the right and left speakers and pipes.
[Note]
≥
To prevent the speaker cables from being pulled out of the pipes, leave the plastic wrap on the pipes while assembling the speaker stands.
≥
The front and surround speaker pairs as well as the pipe pairs are different.
–Check the label on the rear of the speaker before attaching the pipe (
➜
page 6).
–The pipe with the shorter cable is for the front speaker.
1
Assemble the speaker stands.
1
Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the hole, and then pull
the rest of the cable through the base.
2
Insert the pipe.
3
Secure the pipe to the base.
Ensure the screws are securely fastened.
2
Attach the stands to the speakers.
Ensure the stand is fastened on straight by gradually tightening the
top and bottom screws alternately until fully tightened.
You can also attach to the lower rear of the speaker.
The height of the speaker can be changed when attaching the
stand to the upper rear or lower rear of the speaker.
3
Connect the speaker cables.
4
Secure the speaker cables to the bases.
STEP
1
Speaker assembly
The supplied stands are specially designed for attachment
to Panasonic SB-FS930 front speakers or SB-FS880
surround speakers. Use only as indicated in this setup.
2 Front and
2 Surround speakers
4 Bases
4 Pipes
8 Short screws
8 Long screws
≥
2
k
pipes with short cable:
For front speakers
≥
2
k
pipes with long cable:
For surround speakers
Cable
Base
Leave the excess speaker
cable for connecting later.
Plastic wrap
Insert the pipe while gently
pulling on the speaker cable.
Match the groove and these
holes with the base when you
insert the pipe.
Pipe support
Pipe
Base
Groove
Short screws
Phillips-head screwdriver
(not included)
Before proceeding to the next step, please remove the plastic
wrap from the pipe.
Speaker
Long screws
Pipe
Twist off the vinyl ends of the
speaker cables.
Rear of the speaker
_
:
Copper
`
:
Silver
Push!
If there is any excess speaker cable, thread the speaker cable
into the opening near the top of the pipe while pulling the speaker
cable from the bottom of the base.
Press the speaker cable into the groove.
Rear side
of base
Press the speaker cable into
the base cover groove as far
as possible.
Cable
Groove
Spe
a
k
e
r as
semb
ly
HT930GCS.book Page 4 Friday, March 11, 2005 10:52 AM
Summary of Contents for SCHT930 - DVD THEATER RECEIVER
Page 35: ...35 RQT7985 MEMO ...