9
Operating Instructions
Assembling the unit
Refer to the following when placing this unit on a table or in a rack. For wall mount, refer to
the wall mounting installation instructions. (
>
20)
Preparation
≥
To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
≥
Keep the screws out of reach of children to prevent swallowing.
≥
Do not hold this unit in one hand to avoid injury by dropping this unit when carrying.
1
On the rear of the unit:
Place the wall mount bracket by aligning the holes in the wall mount bracket
with the projecting parts
A
.
2
Screw the wall mount bracket firmly into place.
≥
Screw tightening torque: 80 N
0
cm to 120 N
0
cm.
≥
Repeat the steps above when installing the second wall mount bracket.
3
Thread a cord (not supplied) through each wall mount bracket.
≥
Make sure to use a cord which is capable
of supporting over 20 k
g
.
B
Rear of this unit
C
Fall prevention
cord
(not supplied)
4
After all the necessary connections are finished (
>
10)
Place the unit in the desired position and attach each cord onto the rack or
table.
≥
Attach each cord to a different screw eye.
≥
Make sure that there is no more than a 3 cm slack.
A
This unit
B
Fall prevention cord (not supplied)
C
Rack or table
D
Screw eye (not supplied)
≥
Attach at a position capable of supporting over
20 k
g
.
Professional installation is required.
The installation should never be done by any other than a qualified installation specialist.
To prevent the unit from falling
E.g.,
SCHTB10EB_RQTX1166-B.book Page 9 Thursday, June 10, 2010 3:06 PM
