3
4
5
1
2
3
6
A
B
2
1
Cable
Screw
Tighten securely.
Secure the stand to the base.
Slide the speaker cable into the groove.
Adjust the speaker height.
Preparation
Attach screw eyes (not included) to secure the front speakers to the
wall (
diagram right).
You will need to obtain the appropriate screw eyes to match the
walls or pillars to which they are going to be fastened.
The walls or pillars to which the screw eyes are going to be
fastened should be capable of supporting 30 kg (66 lbs). Consult a
qualifi ed housing contractor concerning the appropriate procedure
when attaching to a concrete wall or a surface that may not
have strong enough support. Improper attachment may result in
damage to the wall or speakers.
To prevent the speaker from falling over, thread the string (not
included) from the wall to the speaker as shown and tie tightly.
Loosen the screws until the speaker can slide up
and down the stand.
Raise the speaker to the desired height, and then
retighten the screws.
Connect the speaker cable.
Phillips-head
screwdriver
: White
: Blue
Push!
Press the speaker cable into the
groove.
Push excess cable back through
the slider hole.
String
(not included)
Screw eye
(not included)
Wall
Rear of the speaker
Approx. 150 mm
(5
29
/
32
)
Secure the speaker cable to
the base.
Preventing the front speakers from falling over
Insert the wire fully.
RQT8656-P.indd 3
RQT8656-P.indd 3
2006/02/28 16:52:08
2006/02/28 16:52:08
