VQT2R71
22
Functions and settings
Play
Functions and settings
To return to the previous
display/To cancel during setting
operation (
➜
page 23): Press
[ RETURN].
Using “WHISPER-MODE SURROUND”
This function is effective during surround playback only. You can enjoy the dynamic effect
even if the sound volume level is low during surround playback.
Press [WHISPER-MODE SURROUND] to select “
W.S. ON
”.
• The current setting is displayed first.
Each time you press, the setting switches between “
W.S. OFF
” and “
W.S. ON
”.
To cancel
Press [WHISPER-MODE SURROUND] to select “
W.S. OFF
”.
• WHISPER-MODE SURROUND is not effective in the following cases.
When not using the surround speakers:
When Dolby Virtual Speaker is off.
When using the surround speakers:
When Dolby Pro Logic and SFC are off with 2-channel signal input.
• If the above setting is made when this function is on, this function temporarily becomes off.
Using “GAME”
Enjoy gaming with more dynamic sound.
Press [GAME].
• “
GAME
” mode (
➜
page 19) in SFC is selected.
To cancel
Press again.
If cancelled, SFC’s effect itself is cancelled.
Muting
“
MUTE
” blinks on the display while the volume is muted.
Press [MUTE].
To cancel
Press again.
• Muting is cancelled when you switch the system to standby.
• Muting is also cancelled when you adjust the volume.
Adjusting the bass (woofer part) output
When you feel the bass volume is not balanced with the volume of the front speakers, you
can adjust the bass during playback.
1. Press [CH] to select “
WFR
”.
(The speaker is switched each time you press the button.)
WFR
(woofer)
→
RS
(surround right) (when used)
→
LS
(surround left) (when used)
2. Press [SPEAKER LEVEL +, –] to adjust the bass volume.
Adjustment
range:
MIN
,
1
to
15
,
MAX
Adjusting the surround speaker output
When using the surround speakers, you can adjust them, too.
1. Press [CH] to select “
RS
” or “
LS
”.
(The speaker is switched each time you press the button.)
WFR
(woofer)
→
RS
(surround right)
→
LS
(surround left)
2. Press [SPEAKER LEVEL +, –] to adjust the volume of each
speaker.
Adjustment
range:
–10
to
+
10
Repeat steps 1 and 2 to adjust the level of each speaker.
• You cannot adjust the front speakers with this operation. To adjust the volume balance
of left and right front speakers, see “Adjusting the volume balance of front speakers”.
(
➜
page 23)
• If the sound is distorted, lower the level.
• You cannot adjust the output level of speakers if the sound field effect is off and the
speakers’ audio output is set to off. (
➜
page 19)
• You can adjust the speaker’s output level in SFC’s each mode respectively. (
➜
page 19)
• When a commercially available active subwoofer is connected to the subwoofer output
terminal on this unit’s rear panel, the subwoofer is synchronized with the unit and the
sound volume is adjusted.
Note
Note
Note
