EN46
Display
電源中斷
• Notifies you of power failure during operations.
If power fails for less than 10 minutes, the operations will resume when
power supply resumes.
(Unsuccessful bread-making may occur sometimes)
• It will still display when the power plug is plugged in after it is removed.
Display
• The oven temperature rises high due
to continuous use. (above 40 °C)
Open the lid to reduce heat
inside of the main unit fully.
(Cool down for about 1 hour after
baking is finished)
Display
~
• Failure
•
Please contact with Panasonic service centre for repair.
In case of the following displays
When the following
conditions happen
Causes
Solutions
Abnormal sounds
on the blade
• There is a clearance between the blade and the shaft.
(The front end moves by 3 cm or so.)
Plug into the
outlet, the current
time on display is
"0:00"
• The lithium battery is at the end of its working life.
•
Before replacement of battery, operations can be
continued with power plug inserted.
•
Set the current time whenever you use the timer
functions.
Please send to the service centre
for professional maintenance staff
to replace the battery.
Powders still
remain and baking
does not occur
• Have you forgotten to install the blade?
Install the blade. (P. EN12)
• Is the blade shaft excessively fastened in the
bread pan so that it cannot move.
Please replace the main shaft
bearing if the blade shaft does not
rotate.
Please consult your Panasonic
customer service centre.
Dough is leaking
out at the bottom
of the bread pan
• A small amount of dough leaks out from
the discharge port of the bread pan during
operations.
To avoid affecting the
rotations, the dough that
enters the rotational part
will be discharged.
This is normal.
Please confirm if the
blade is rotating.
The bottom of the
bread pan turns
black
• The bottom of the bread pan may turn black due to frictions when kneading.
In that case, please wipe and clean with a damp kitchen towel.
• Smokes or odors may occur upon initial use. However, they will disappear some time after use. Operations are not
affected.
Shaft
Troubleshooting
Discharge port
(4 positions)
At the bottom of
the bread pan
( )
( )
( )
Please confirm the following issues first.
If any anomaly is still identified, please contact Panasonic customer
service centre immediately.
SD-PM107_P36-47.indd 46
3/5/2018 20:12:16