EN28
Troubleshooting
Problem
Cause and Action
The kneading blade rattles.
This is because the kneading blade fits loosely on the kneading mounting shaft. )This is not a fault.(
I can smell burning while the
bread is baking.
Smoke is coming out of the
steam vent.
Ingredients may have been spilt on the heating element.
→
Sometimes a little flour, raisins or other ingredients may be flicked out of the bread pan during
mixing. Simply wipe the heating element gently after baking once the machine has cooled down.
→
Remove the bread pan from the main unit to place ingredients.
Dough leaks out from
bottom of the bread pan.
A small amount of dough will escape through the ventilation holes )so that it does not stop the
rotating parts from rotating(. This is not a fault, but check occasionally that the kneading mounting
shaft rotate properly.
→
If the kneading mounting shaft does not rotate when the kneading blade is attached, you will need to
replace the kneading mounting shaft unit. )Consult the place of purchase or Panasonic service center.(
Kneading mounting shaft
Ventilation holes )4 in total(
)Bottom of bread pan(
Part no. ADA29E226
Kneading
mounting shaft unit
Kneading
mounting shaft
Puzzle
“1” appears on the display
and operation has been
stopped.
When the power supply to machine is interrupted for a certain time, the display shows “1” after
recovered. )It is standby mode and machine could not continue the program.(
→ Remove the bread, dough or ingredients and start again using new ingredients.
“H01”, “H02
”
appears on the
display.
The display indicates a problem with the machine.
→ Consult the place of purchase or a Panasonic service center.
“U50
”
appears on the display.
The machine is hot )above 40 °C(. This may occur with repeated use.
→ Allow the machine to cool down to below 40 °C before using it again )U50 will disappear(.
Display exception
When making jam, can we
use fruits are pickled in
alcohol?
Do not use them. The quality is not satisfactory.
The fruit has collapsed when
making compote.
The cooking time was too long. The fruit may have been over ripe.
During or after cooking
Before calling for service, please check through this section.
Troubleshooting
UAE_YR250 Pagination_20210724.indd 28
UAE_YR250 Pagination_20210724.indd 28
2021/11/8 17:28:57
2021/11/8 17:28:57
