© Panasonic Industrial Devices SUNX Co., Ltd. 2014
8
Introduction
WARNING
♦
Machine in which this device is installed
● When this device is used in the “PSDI Mode,” an appropriate control circuit must be config
-
ured between this device and the machinery. For details, be sure to refer to the standards
or regulations applicable in each region or country.
●
In Japan and China, Korea, do not use this device as safety equipment for a press ma-
chine.
●
Do not install this device with a machine whose operation cannot be stopped immediately
in the middle of an operation cycle by an emergency stop equipment.
● This device starts the performance after 2 seconds from the power ON. Have the control
system started to function with this timing.
♦
Wiring
● Be sure to carry out the wiring in the power supply OFF condition.
● All electrical wiring should conform to the regional electrical regulations and laws. The wir
-
ing should be done by engineer(s) having the special electrical knowledge.
●
Do not run the wires together with high-voltage lines or power lines or put them in the
same raceway. This can cause malfunction due to induction.
●
In case of extending the cable of the emitter or the receiver, each can be extended up to
50m by using the exclusive cable. Extending the cable longer than 50m may cause mal
-
function, which can result in death or serious injury.
● Do not control the device only at one control output (OSSD 1 / 2).
●
In order that the output is not turned to ON due to earth fault of the control output (OSSD 1
/ 2) wires, be sure to ground to 0V side (PNP output) / +V side (NPN output).
● When using this device in Korea with S-mark, be sure to ground to 0V side (PNP output).
♦
Maintenance
●
When replacement parts are required, always use only genuine supplied replacement
parts. If substitute parts from another manufacturer are used, the device may not come to
detect, result in death or serious injury.
●
The periodical inspection of this device must be performed by an engineer having the spe-
cial knowledge.
●
After maintenance or adjustment, and before starting operation, test this device following
the procedure specified in “
Chapter 4 Maintenance
.”
● Clean this device with a clean cloth. Do not use any volatile chemicals.
♦
Others
● Never modify this device. Modification may cause the device not to detect, resulting in
death or serious injury.
● Do not use this device to detect objects flying over the sensing area.
●
Do not use this device to detect transparent objects, translucent objects or objects smaller
than the specifi ed minimum sensing objects.
Ramco National
800-280-6933 | nsales@ramcoi.com
www.panasonicsensors.com
