DJ Mixer
Fader Replacement Instructions
First, remove the AC power supply cord (AC mains
lead) and follow the steps below to replace with a
new fader.
1
Remove all five channel fader,
cross fader knobs, and the re-
placement panel
Remove the four plate screws on the replace-
ment panel.
Replacement panel
2
Remove the channel fader or
cross fader to be replaced
Do not let the screws fall inside the
unit.
-1 Remove the two fader fastening
screws
-2 Remove the fader
Channel fader
Turn on an angle and lift to remove.
Cross fader
Turn on an angle and lift to remove.
-3 Remove the fader cable while hold-
ing the 3 pin connector
3 pin connector
-4
Cross fader
Remove the two fastening screws, the
optical device unit, and then the cross
fader.
• Move the lever toward the center and
remove.
• Do not change the shape of the optical
device unit or the 4 pin terminal.
Lever
4 pin terminal
3
Attach the new channel fader or
cross fader
Attach by performing the opposite of the re-
move step.
4
Attach the replacement panel and
knobs
