12
How to Use
About ECONAVI operation
How to set temperature
About defrosting
< Refrigerator >
Initial Setting: 3
℃
Temperature setting range: -6
℃
to 12
℃
< Freezer >
Initial Setting: -20
℃
Compartment
temperature display
Temperature
adjustment
button
Temperature
setting button
Temperature setting range: -25
℃
to -15
℃
■
ECONAVI operation automatically performs cooling operation by judging the
installed and used condition of the refrigerator or freezer and saving energy
according to the environment.
■
ECONAVI lamp will be turned off when ECONAVI operation is cancelled.
■
During ECONAVI operation, ECONAVI lamp is turned on.
Compartment temperature has been set at 3
℃
(refrigerator) and -20
℃
(freezer) at the time of
shipment.
When temperature setting is necessary, follow the
direction shown below.
■
Defrosting of the cooling unit is automatically executed approximately every 6 hours.
●
After defrosting, the compartment temperature will rise slightly, but impact on food
temperature is minimal and the product can be used continuously.
●
In the case of power failure, defrosting starts in approx 6 hours after power recovery.
●
Forced defrosting can be started by pressing the temperature adjustment buttons
" " and " " at the same time for 3 sec or longer, with the next defrosting
starting in approx 6 hours later.
■
When changing the set temperature.....
●
Press the temperature setting button " ".
(The display changes to setting mode.
Compartment temperature display blinks to
show the set temperature.)
●
Press Temperature Adjustment button " "
or " ", and set the desired temperature
within the range of adjustment.
●
Press the temperature setting button " "
again.
(Setting is memorized and changes to the
display mode.
Compartment temperature is displayed in the
compartment temperature indicator.)
■
During defrosting, compartment temperature indicator displays " ".
ECONAVI lamp may be turned off temporarily during ECONAVI operation
according to the installed and used condition, but it is not a failure.
Note
After 1 minute without any operation, the display
changes to indication mode. In such a case,
setting is not memorized and the setting is left
as before.
Note
