18
How to Inspect and Care
About error code display
■
When a problem occurs while using the product, an error code is
displayed in blinking in the compartment temperature display.
Check the following and if the error code still remains, contact the
product distributor.
＊
" " error indication does not disappear until the power plug is
disconnected.
Correct the problem and after 5 minutes, reconnect the power plug.
When the same error code appears after operation for 1 hour so,
contact your distributor.
Error
code
Content
Please check
Action to be taken
＊
Isn't the ambient temperature
35
℃
or higher?
Lower the ambient temperature
by ventilation or air-conditioning.
Isn't any hot food stored inside?
Isn't the ambient temperature
5
℃
or below?
Fully cool hot food before storing it
in the refrigerator.
Isn't any frozen food being
thawed?
When this error code does not
disappear even after removing the
food, contact the product distributor.
Isn't any warm food stored inside?
Fully cool warm food before storing
it in the refrigerator.
Hasn't the door been opened
frequently or left open?
Long opening time of the door
reduces freezing or refrigeration
effect. Reduce door opening
frequency or duration of door
opening.
Is the ventilation of the place of
installation (fan, air-conditioning)
sufficient?
Increase ventilation of the room.
Locate the product far from a
heat-generating equipment.
Isn't the suction or blowout
opening blocked by food?
Secure sufficient cool air path.
Isn't the ambient temperature
35
℃
or higher?
Lower the ambient temperature by
ventilation or air-conditioning.
Isn't the condenser filter or
condenser itself contaminated?
Clean the components.
(Please see Page 15,16)
Please contact your distributor for
inspection method.
Is the door fully closed?
Close the door again.
Raise the ambient temperature
by ventilation or air-conditioning.
[Notice]
This error code is also displayed
when the ambient temperature is
lower than the set temperature.
Compartment
temperature is
high
Compartment
temperature is
low
Compartment
fan locked
warning
Condenser filter
clogging
warning
Sensor or other
component
abnormality
warning
Other
indication
