47
9 Service Position
9.1.
Main Speaker Unit
Note: For description of the disassembly procedures, see the Section 8
9.1.1.
Checking Tilt Switch P.C.B.
Step 1 :
Remove Rear Cabinet Block.
Step 2 :
Remove Tilt Switch P.C.B..
Step 3 :
Place the Tilt Switch P.C.B. on an insulated material.
Step 4 :
Connect 2P wire to connector (CN6301) on Tilt Switch P.C.B..
Step 5 :
Place support block at both sides of the Front Panel Block.
9.1.2.
Checking SMPS P.C.B.
• Refer to (Step 1) - (Step 3) of item 9.1.1.
Step 1 :
Remove SMPS P.C.B..
Step 2 :
Connect 2P wire to connector (CN6301) on Tilt Switch P.C.B..
Step 3 :
Place SMPS P.C.B. on an insulated material.
Step 4 :
Connect 7P wire to connector (CN1) on SMPS P.C.B..
Step 5 :
Place support block at both sides of the Front Panel Block.
Summary of Contents for SU-HTB485EB
