B
e
fore Use
19
Turning the Power On
1
Insert the battery and connect the AC adaptor.
(p. 17)
•
The unit can be operated using only the battery, but when using PC mode, the AC
adaptor must be connected, otherwise the unit will not turn on.
2
Place unit on a flat, level surface.
•
If this is not done, the HDD SAFETY Switch may prevent the unit from operating.
(p. 20)
3
Press STANDBY for approx. 2 seconds.
•
The power comes on (POWER Lamp lights) and the
unit cycles through each operating mode in sequence.
(p. 13)
– Note –
• If using the unit on battery power only, the power will turn off automatically if no unit operations
are carried out for 5 minutes, in order to conserve battery power.
• The power cannot be turned off while the HDD SAFETY Detection Switch has been activated.
(p. 20)
In case of a power outage, the unit utilises the supplied battery as a backup
in order to protect the unit and the card data. If you are using the AC adaptor,
insert a sufficiently charged battery before turning on the power. The unit
cannot be used if only the AC adaptor is used.
To turn this unit off :
Press STANDBY for approx.
2 seconds.
Eng.p18-20.p65
2003/02/13, 16:48
19