- 19 -
Alignment
(The reference figures below are normal and used for representative purpose only.)
DS contrast
1)
Input 1Vp-p PAL Composite colour bar signal into the video in terminal.
2)
Access the DS contrast mode and align as follow.
Video signal setting
1)
Input 1Vp-p PAL Composite colour bar signal into the Video in terminal.
2)
Set Picture mode to Normal mode and Manual W/B to Cool position.
3)
Access the Video signal Adj. Mode and set each Item as follow.
4)
Record the setting data of Sub contrast, R Drive and B Drive.
5)
Access the SG Hold mode(Forced signal system set mode) and set the system to NTSC.
6)
Return to the Video signal adj. mode and copy the Data 1 for each item.
7)
Repeat item 5) and 6) for SECAM , 525i, 625i and 525p system.
Chroma Control
1)
Access the Chroma Control Mode and set each Item as follow.
2)
Record the setting data of Sub Tint and Sub Colour.
3)
Access the SG Hold mode(Forced signal system set mode) and set the system to NTSC.
4)
Return to the Chroma Control mode and copy the Data 2 for each item.
5)
Repeat item 3) and 4) for SECAM and 525i system. (Sub colour data for SECAM system should be reduced 5 steps
from data 2.)
Alignment Item
Reference
Setting/Special feature
Sub Contrast
66
0.7V pedestal-peak on TP216.
Alignment Item
Reference
Setting /Special feature
Sub Brightness
80
Fixed data
R Cutoff
40
Fixed data
B Cutoff
40
Fixed data
Sub Contrast
63
Set the signal on TP294 to 0.7V pedestal-peak.
R Drive
71
Set the signal on TP293 to 0.7V pedestal-peak.
B Drive
71
Set the signal on TP295 to 0.7V pedestal-peak.
G Cutoff
80
Fixed data
G Drive
20
Fixed data
Sub Contrast
R Drive
B Drive
Alignment Item
Reference
Setting/Special feature
R-Y Axis Angle
E
Fixed data
R-Y Axis Gain
2E
Fixed data
Sub Tint
47
Optimum setting
Sub Colour
30
Optimum setting
Sub Tint
Colour
**Data 2
**Data 1
( !"
Summary of Contents for TC-42PD1F
