Operating Instructions
35
8 Configure the settings related to images [Image]
Enter a multicast IP address after checking available multicast address.
[Multicast port]
*2
Enter the multicast port number (used to transmit images from the unit).
Available port number:
1024 - 50000 (Only even numbers are available.)
Default:
37004
Note
The following port numbers are unavailable since they are already in use.10669, 10670
[Multicast TTL/HOPLimit]
*2
Enter a value for “Multicast TTL/HOPLimit”.
Available value:
1-254
Default:
16
IMPORTANT
When transmitting an H.264 image via a network, the transmitted image sometimes may not be
displayed depending on the settings of a proxy server or a firewall. In this case, refer to the network
administrator.
When two or more network interface cards are installed on the PC in use, the network interface card(s)
not used for receiving images should be invalidated when displaying images using the multicast port.
[Smoother live video display on the browser (buffering)]
Perform settings to display unit images on the viewer software.
On:
Images are temporarily stored on the computer and are displayed smoother.
Off:
Images are displayed in real-time and are not stored on the computer.
Default:
Off
IMPORTANT
If it appears that there is a delay in the images being displayed, select “Off”.
*1
It
is necessary to designate the unicast port number when “Unicast port (MANUAL)” is selected for “Transmission type”.
*2
It is necessary to designate the multicast IP address when “Multicast” is selected for “Transmission type”.
8.4
Configure the settings relating to image and
positions [Image/Position]
Click the [Image/Position] tab on the “Image” page. (section 6)
