Operating Instructions
45
10 Configure the alarm settings [Alarm]
5.
To delete the VMD area, click the [Delete] button corresponding to the area to be deleted.
The outline of the respective VMD area will disappear.
6.
Click the [Set] button.
The edited settings will be applied.
10.4 Configuration of the settings relating to the E-
mail notification [Notification]
Click the [Notification] tab on the “Alarm” page. (section 6)
The settings relating to the alarm E-mail can be configured. It is necessary to configure the settings of the
E-mail server to perform the E-mail notification. (section 12)
E-mail notification
[E-mail server >>]
When “E-mail server >>” is clicked, the [E-mail] tab of the “Server” page will be displayed. (section 12)
[E-mail notification]
Select “On” or “Off” to determine whether or not to provide notification by E-mail according to the settings for the
“Alarm” and “Diag.” checkboxes of “Destination of notification” below.
Default:
Off
Destination of notification
[Address 1] - [Address 4]
Enter the destination E-mail address. Up to 4 destination E-mail addresses can be registered.
[Alarm] checkbox:
When the checkbox is selected, the E-mail notification will be sent when an alarm
occurs or when a video loss is recovered.
[Destination E-mail address]:
Enter the destination E-mail address.
–
Available number of characters:
3 - 128 characters
–
Available characters:
Alphanumeric characters, the at sign (@), the period (.), the underscore (_),
and the hyphen (-).
