50
Operating Instructions
11 Configure the settings relating to the authentication [User mng.]
When the IP address already in use is entered and the [Set] button is clicked, the respective host
information will be overwritten.
[Access level]
Select the access level of the host from the following.
1. Administrator/ 2. Camera control/ 3. Live only
Refer to section 11 for further information about the access level.
Default:
3. Live only
[Host check]
From the pull-down
menu of “Host check”, the registered host can be selected and the selected host’s IP
address can be checked.
The registered IP address will be displayed with the access level. (Example: 192.168.0.21 [1])
To delete the registered host, click the [Delete] button after selecting the IP address to be deleted.
11.3 Configure the settings relating to the priority
stream [System]
Click the [System] tab on the “User mng.” page. (section 6)
The description below is the configuration of the priority stream that can transmit images without deteriorating
the image quality and refresh interval even when multiple users access concurrently.
Priority stream
[Activation]
Select “On” or “Off” to determine whether or not to use the priority stream.
Default:
Off
Note
When
“On” is selected for “Activation” of “Priority stream”, number of users who can access the camera may
be limited.
[Destination IP address(1)]
Enter the first destination IP address.
Default:
None (blank)
[Destination IP address(2)]
Enter the second destination IP address.
Default:
None (blank)
[Stream type]
Select either “JPEG”, “H.264(1)” or “H.264(2)”.
JPEG:
JPEG images will be transmitted.
