52
Operating Instructions
12 Configure the settings of the servers [Server]
12 Configure the settings of the servers
[Server]
The settings relating to the E-mail server, the FTP server and the NTP server can be configured on this page.
The “Server” page has 3 tabs; the [E-mail] tab, the [FTP] tab and the [NTP] tab.
12.1 Configure the settings relating to the E-mail
server [E-mail]
Click the [E-
mail] tab on the “Server” page. (section 6)
The settings relating to the E-mail server used to send the alarm E-mail can be configured on this page.
IMPORTANT
When a terminal that receives E-mails is not compatible with UTF-8 encode, it is impossible to receive alarm
E-mails correctly.
[SMTP server address]
Enter the IP address or the host name of the SMTP server used to send E-mails.
Available number of characters:
1 - 128 characters
Available characters:
Alphanumeric characters, the colon (:), the period (.), the underscore (_), and
the hyphen (-).
Default:
None (blank)
[SMTP port]
Enter the port number to which E-mails are sent.
Available port number:
1-65535
Default:
25
The following port numbers are unavailable since they are already in use:
20, 21, 23, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[POP server address]
When “POP before SMTP” is selected for “Type”, enter the IP address or the host name of the POP server.
Available number of characters:
1 - 128 characters
Available characters:
Alphanumeric characters, the colon (:), the period (.), the underscore (_), and
the hyphen (-).
Default:
None (blank)
IMPORTANT
When entering the host name for “SMTP server address” or “POP server address”, it is necessary to
configure the DNS settings on the [Network] tab of the “Network” page. (section 13)
