62
Operating Instructions
13 Configuring the network settings [Network]
Note
The unit will restart after the connection setting is changed.
When using the self-signed certificate:
If the unit is accessed using the HTTPS protocol for the first time, the warning window will be displayed. In
this case, follow the instructions of the wizard to install the self-signed (security) certificate.
(section 13.3)
When using the server certificate:
In advance, install the root certificate and intermediate certificate on the browser in use. Follow the
instructions of CA for how to obtain and install these certificates.
When the unit is accessed using the HTTPS protocol, the refresh interval and frame rate of images may be
lower.
When the unit is accessed using the HTTPS protocol, it may take time to display images.
When the unit is accessed using the HTTPS protocol, the images may be distorted.
The maximum number of concurrent access user varies depending on the maximum image size and
transmission format.
[FTP access to unit]
Select “Allow” or “Forbid” to determine whether to allow or forbid the FTP access to unit.
Default:
Forbid
[Bandwidth control(bit rate)]
Select the total bit rate for data transmission from the following.
Unlimited/ 64kbps/ 128kbps/ 256kbps/ 384kbps/ 512kbps/ 768kbps/ 1024kbps/ 2048kbps/ 4096kbps/
8192kbps
Default:
Unlimited
Note
Select
“128kbps” or a faster rate to carry out the live transmission of JPEG images and the FTP periodic
image transmission simultaneously.
When “Bandwidth control(bit rate)” is set low, taking a picture using the snap shot button may not function
depending on th
e use environment. In this case, select “QVGA” for “Image capture size” of “JPEG” on the
[JPEG/H.264] tab or set “Image quality setting” of “JPEG” lower.
[Easy IP Setup accommodate period]
Select “20min” or “Unlimited” to determine how long the network setting operation using the Panasonic “IP
Setting Software” can be allowed.
20min:
The network setting operation using the Panasonic
“IP Setting Software” are allowed for 20
minutes since the unit starts up.
Unlimited:
The network setting operation using the Panasonic “IP Setting Software” are allowed without
time limitation.
Default:
20min
Note
The camera information display using the Panasonic “IP Setting Software” is allowed without time
limitation, and unit images can be opened.
Refer to the network administrator for the addresses of each server.
The port forwarding function changes a global IP address to a private IP address, and “Static IP
masquerade” and “Network Address Translation (NAT)” have this function. This function is to be set in a
router.
To access the unit via the Internet by connecting the unit to a router, it is necessary to assign a respective
HTTP port number for each unit and address translation by using the port forwarding function of the router.
For further information, refer to the operating instructions of the router in use.
