Operation
25
Using the external sound control
The external sound control function switches between Noise cancelling and Ambient sound.
1
While wearing the earphones, touch and hold the touch sensor (R) for about 2 seconds.
• The mode is switched each time you touch and hold the touch sensor. (A guidance message will notify you of the
mode you switched to.)
[EAH-AZ60]
• The default level setting is “Noise cancelling”.
• When the “Technics Audio Connect” app is used, you can set to “OFF”.
[EAH-AZ40]
• The default level setting is “Ambient sound OFF”.
2
Adjust the volume of the playback device.
∫
Noise cancelling (
[EAH-AZ60]
only)
Reduces the sounds (noise) you can hear from outside.
• Noise cancelling can be optimised with the “Technics Audio Connect” app. Adjust it beforehand to achieve the best
condition.
• While using the noise cancelling function, a very small amount of noise which is generated from the circuit that
reduces noise may be heard, but this is normal and not indicative of any trouble. (This very-low-level noise may be
heard in quiet places or in the blank parts between tracks.)
∫
Ambient sound
You can hear ambient sound through the microphones embedded in the earphones while enjoying music.
Noise cancelling
Ambient sound
Ambient sound
Ambient sound
OFF
eah̲az60̲az40̲pnqp1654ya̲full̲eng̲s.book 25 ページ 2021年12月21日 火曜日 午後5時18分