Other
29
Restoring to the factory settings
When you want to delete all pairing device information, etc. in the earphones, you can restore the earphones to
the factory settings (original settings upon purchase).
1
Put both earphones (L and R) into the charging cradle to charge the earphones fully.
2
Take the R side earphone out of the charging cradle.
3
While the earphone LED lights (blue) (about 5 seconds), touch and hold the touch
sensor (R) for about 7 seconds.
• The earphone LED will light alternately in blue and red.
4
Release your finger from the touch sensor (R).
5
Touch and hold the touch sensor (R) for about 10 seconds.
• The earphone LED (blue) blinks rapidly, and when the power turns off, the earphone returns to the factory
settings.
6
Do the same Steps 2 to 5 above for the L side earphone.
Note
• To re-pair the earphones with a Bluetooth
®
device, delete the registered information (device name: EAH-AZ60 or
EAH-AZ40) on the device, then pair the earphones with the Bluetooth
®
device again. (
• Some setting values, such as the language settings for voice prompts and Amazon Alexa, are kept.
eah̲az60̲az40̲pnqp1654ya̲full̲eng̲s.book 29 ページ ２０２１年１２月２１日 火曜日 午後５時１８分
