1
2
1
2
SERIAL
PC IN
AUDIO
SLOT2 SLOT3
P
R
/C
R
/R P
B
/C
B
/B
Y/G
AUDIO
R
L
COMPONENT/RGB IN
SLOT1
8
Connections
– Cable
fi
xing bands
Secure any excess cables with bands as required.
Pass the attached cable
fi
xing band through the
clip as shown in the
fi
gure.
To secure cables connected to Terminals, wrap the cable
fi
xing band around them
then pass the pointed end through the locking block, as shown in the
fi
gure.
While ensuring there is suf
fi
cient slack in cables to minimize stress (especially
in the power cord),
fi
rmly bind all cables with the supplied
fi
xing band.
To tighten:
To loosen:
Pull
Pull
Push the catch
AC cord connection (see page 12)
– AC cord
fi
From EXTERNAL
monitor terminal
on Computer
(see page 9)
From SERIAL
Terminal
on Computer
(see page 10)
Note:
At factory shipment, Terminal board is installed in SLOT 1 only.
COMPONENT/RGB IN and Audio
IN Terminals (equivabent to
BNC Component Video Terminal
Board (TY-42TM6A))
(see page 11)
Optional Terminal
Board Insert Slot
(covered)
Optional Terminal
Board Insert Slot
(covered)
Note:
Make sure that the AC cord is locked
on both the left and right sides.
Push until
t h e h o o k
clicks.
1.
Keep the
knob
pressed.
Unplug the AC cord
Unplug the AC cord pressing
the two knobs.
Close
Open
1
Plug the AC cord into
the display unit.
Plug the AC cord until
it clicks.
2
Fix the AC cord with
the clamper which is
attached to the unit.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug
at the socket outlet
fi
rst.
2.
Pull off.
Summary of Contents for TH-37PR10A
Page 50: ...50 Memo ...
Page 51: ...51 Memo ...