Project Name
Module name
OK
SIACP VERSION
SIACP VERSION
OK
Chassis
MS306 Chassis name
OK
PANEL NAME
P/N of panel
OK
NG
PROJECT ID
>>>
Select panel ID Number
OK
CONFIG
>>>
Project Select submenu
USB UPDATE
>>>
USB UPDATE
ok
HOTEL ENABLE
OFF
HOTEL MENU SWITCH
NOT
USE
ReloadEFBItem
Do
Only for factory adjust
OK
CONFIG submenu
ITEM
Default
Setting
Description
Status
Erase HDCP Key Do
Only for R&D
OK
Reset HDCP Key Do
Only for R&D
OK
UsbHdcpkey
Update
Do
Only for R&D
OK
5. Debugging
5.1. General Steps of debugging
According to the requirement of the order, below steps are needed for
appropriate setting.
1)
Enter the Factory Menu, enable FAC HOTKEY.
2)
Check Project ID and the version of software, release date displayed
at the bottom of Factory Menu.
3)
Enter Design Menu, choose SERVICE MENU->Project ID, choose
corresponding Project ID number of the product (Refer to the
“V6-PROJECT -ID0**”in the BOM list).
4)
Return to Factory Menu, check the Product model.
5)
Choose Factory Menu->NVM RESET and press the right button of the
remote and wait until prompt OK appears.
6)
Restart the set
7)
According to the requirement of the order, Set the items of SHOP
INIT and Hotel Menu etc.
8)
After aging under normal temperature, calibrate ADC and adjust
white balance.
Summary of Contents for TH-40C200DX
Page 33: ......
