15
Connections
Basic format for control data
The transmission of control data from the computer
starts with a STX signal, followed by the command, the
parameters, and lastly an ETX signal in that order. If there
are no parameters, then the parameter signal does not
need to be sent.
Start
(02h)
3-character
command (3 bytes)
Colon
Parameter(s)
(1 - 5 bytes)
End
(03h)
STX
C1 C2 C3
P1 P2 P3 P4
:
P5
ETX
Notes:
$ If multiple commands are transmitted, be sure to wait
' ' '
' +
$ If an incorrect command is sent by mistake, this unit will
Z_^ &+
$ Consult an Authorized Service Center for detail
instructions on command usage.
$ With the power off, this display responds to PON
command only.
Command
Command Parameter Control details
PON
None
Power ON
POF
None
Power OFF
AVL
***
Volume 000 - 100
AMT
0
Audio MUTE OFF
1
Audio MUTE ON
IMS
None
VD1
YP1
HM1
DV1
DV2
PC1
DL1
DP1
UD1
Input select (toggle)
VIDEO IN input (VIDEO)
K*K""QZ "
(Component)
HDMI input (HDMI)
DVI-D1 IN input (DVI-D1)
DVI-D2 IN input (DVI-D2)
PC IN input (PC)
!!"#
DisplayPort input
USB input
DAM
None
KK*
FULL
NORM
K*]
Screen mode select (toggle)
^
16:9
4:3
]
IR IN / IR OUT Terminals connection
Use a 3.5 mm stereo mini plug to connect from the IR OUT of the First LCD Display to the IR IN of the Second LCD
Display. The IR signal from the First LCD Display will be sent to the Second LCD Display.
First LCD Display
Second LCD Display
Third LCD Display
* Stereo mini plug (M3)
*
*
At this time, IR receiver of the Second LCD Display will not work.
It is possible to daisy-chained by repeating the above connection.
`$ xz
USB
