51
SETUP
$ This function will start operating once a video signal is detected by both the input in use for viewing and the backup
J%+
Primary Backup Input
J& +
<*:J:!!"#:%=^:%=]:: %K +
The input that is of the same type as the one in use for viewing will be greyed out.
When an analogue (PC, Component or VIDEO) input is being used for viewing, you cannot set an analogue (PC,
Component or VIDEO) input as a backup input.
Any analogue (PC, Component or VIDEO) input cannot be set as Primary Backup Input or Secondary Backup
Input.
Secondary Backup Input
Sets the second priority backup input.
<*:J:!!"#:%=^:%=]:: %K +
The input that is of the same type as the one in use for viewing will be greyed out.
When an analogue (PC, Component or VIDEO) input is being used for viewing, you cannot set the analogue (PC,
Component or VIDEO) input as a backup input.
Any analogue (PC, Component or VIDEO) input cannot be set as Primary Backup Input or Secondary Backup
Input.
Auto switch back mode
Sets whether or not to automatically return to the former (main) input when the former input video initially viewed is
restored while viewing the video of the backup input enabled by the operation of the Backup Input function.
OFF: unreturned
ON: returned
Status
Displays whether or not operating conditions for the Backup Input function are met.
INACTIVE: indicates that the conditions are not met, and disables the Backup Input function.
ACTIVE: indicates that the conditions are met, and enables the Backup Input function.
Main Input
Displays the (main) input initially used for viewing.
Current Input Status
Displays whether the input currently in use for viewing is the (main) input initially used for viewing or the backup
one.
Setting conditions
The following table describes restrictions (available combinations) on each setting item.
Main
HDMI
USB
PC
Component
DisplayPort
or
!!"#
VIDEO
DVI-D1
DVI-D2
Backup
HDMI
o
o
o
DisplayPort
!!"#
DVI-D1
DVI-D2
USB
o
-
o
o
PC
o
-
Component
o
-
or
VIDEO
