11.2. Initialization Pulse Adjust
1. Input the White signal to plasma video input.
2. Set the picture controls as follows.
Picture menu : Dynamic
D. PNR : OFF
Aspect : Full
3. Connect Oscilloscope to TPSC1 (SC).
Check that the flat section is less than 40µ Sec and adjust VR6602 for 160+10µ Sec.
Test point
Volume
Level
T1
TPSC1 (SC)
---
T1 < 40µ Sec
T2
TPSC1 (SC)
VR6602 (SC)
160 ± 10µ Sec
11.3. P.C.B. (Printed Circuit Board) exchange
11.3.1. Caution
1. To remove P.C.B. , wait 1 minute after power was off for discharge from electrolysis capacitors.
11.3.2. Quick adjustment after P.C.B. exchange
Adjust the following voltages with the multimeter.
P.C.B.
Name
Test Point
Voltage
Volume
Remarks
P Board
Vsus
TPVSUS (SS)
Vsus ± 2V
VR251 (P)
*
SC Board
Vad
TPVAD (SC)
-90V ± 1V
VR6600 (SC)
SS Board
Ve
TPVE (SS)
Ve ± 1V
VR6000 (SS)
*
D, DG Board
White blance and Sub brightness for NTSC, PAL, HD, PC and 625i signals
*See the Panel label.
Caution:
Absolutely do not reduce Vsus below Ve not to damage the P.C.B.
38
TH-65PV600A / TH-65PV600M
Summary of Contents for TH-65PV600M
