11
Connection
1
2
1
3
2
1
2
1
2
DEDICATED RECEIVER IN
SERVICE USE
Note:
Please turn off the power of the Plasma Display unit and Digital Media Receiver when connecting or removing Display - Receiver cable.
Display connection
When connecting the speakers, be sure to use only the optional accessory speakers.
For details on installation and connection of the speaker, refer to the Speaker’s Installation Manual. (Supplied)
To DEDICATED DISPLAY OUT
connector on Digital Media Receiver
These terminals are not in use.
Pull
SPEAKER
Terminals (R)
SPEAKER
Terminals (L)
– Cable fixing bands
Secure any excess cables with bands as required.
Speakers (Optional accessories)
Pass the attached cable
fixing band through the
clip as shown in the
figure.
To secure cables connected to Terminals, wrap the cable fixing band around
them then pass the pointed end through the locking block, as shown in the
figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the supplied
fixing band.
To tighten:
To loosen:
Pull
Push the catch
Note:
The power plug in the illustration may not be the type fitted to your set.
– AC cord fixing
Close
Open
Push until the hook clicks.
2.
Pull off.
1.
Keep the knob pressed.
1 . Connect the AC cord plug to the Plasma Display.
2 . Fix the left side clamper.
3 . Fix the right side clamper.
