48
Problem
Actions
Screen
Sound
HDMI
The remote control
does not work
Are the batteries installed correctly? (p. 6)
Has the TV been switched On?
Has the battery run down?
TV goes into
“Standby mode”
Off Timer function is activated.
The TV enters “Standby mode” about 30 min. after
broadcasting ends.
Unusual image is displayed
Turn off the TV with Mains power On / Off switch,
then turn it on again.
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Is the HDMI cable connected properly? (p. 45)
Turn Off the TV and equipment, then turn them On
again.
Check an input signal from the equipment. (p. 46)
Use an equipment compliant with EIA/CEA-861/861B.
Sound is unusual
Set the sound setting of the connected equipment to
“2ch L.PCM”.
Check the “HDMI1 Input” setting in the Sound Menu.
(p. 20)
If digital sound connection has a problem, select
analogue sound connection. (p. 43)
Sound level is low
or sound is distorted
Sound signal reception may be deteriorated.
Check Sound system. (p. 27)
Set “MPX” (p. 20) in the Sound Menu to “Mono”.
No sound is produced
Is “Sound mute” active? (p. 8)
Is the volume set to the minimum?
Blurry or distorted image
(no sound or low volume)
Reset channel. (p. 28)
No image can be
displayed
Is “Colour” or “Contrast” in the Picture Menu set to
the minimum? (p. 20)
Check Colour System. (p. 27)
Check AV Colour System. (p. 21)
Chaotic image, noisy
Set “P-NR” in the Picture Menu (to remove noise). (p. 20)
Check nearby electrical products
(car, motorcycle, fluorescent lamp).
Other
FAQs
TH-L32X10&18KMRSX_EN.indb 48
TH-L32X10&18KMRSX_EN.indb 48
4/30/09 9:11:45 AM
4/30/09 9:11:45 AM
